Page 1 of 1
Custom Go-Devil.
Posted:
Fri Dec 19, 2014 9:42 pmby SethChester
Alright, I have a problem! I have a 20hp Kohler, I want to make it a go-devil. I don't want any cheap kits you can buy online. Then on the other hand I am not paying 2-3k on just a kit. So I'm going to build one with my papa and could I buy the grease fitting some where for the shaft? Any pictures or ideas on a build would be helpful to!
- Thankyou.
Re: Custom Go-Devil.
Posted:
Fri Dec 19, 2014 9:49 pmby Flightstopper
Look up McMaster Carr for bearings, bushings or anything else like it.
Re: Custom Go-Devil.
Posted:
Fri Dec 19, 2014 9:50 pmby Flightstopper
Cold roll steel shaft can be ordered online or have a local shop source it
Re: Custom Go-Devil.
Posted:
Fri Dec 19, 2014 10:11 pmby SethChester
Flightstopper wrote:Look up McMaster Carr for bearings, bushings or anything else like it.
Thankyou, but I need the piece that slides over the engine shaft, and connects to the shaft.
Ex. Look at the sps mud motor kit.
Re: Custom Go-Devil.
Posted:
Fri Dec 19, 2014 10:15 pmby Flightstopper
The yoke and U joint? Auto stores or amazon. Just search for the size shaft yoke you need
Re: Custom Go-Devil.
Posted:
Sat Dec 20, 2014 12:30 pmby capt1972
SethChester wrote:Alright, I have a problem! I have a 20hp Kohler, I want to make it a go-devil. I don't want any cheap kits you can buy online. Then on the other hand I am not paying 2-3k on just a kit. So I'm going to build one with my papa and could I buy the grease fitting some where for the shaft? Any pictures or ideas on a build would be helpful to!
- Thankyou.
They are called zerk fittings, can be had just about anywhere.
Re: Custom Go-Devil.
Posted:
Sat Dec 20, 2014 6:14 pmby SethChester
capt1972 wrote:SethChester wrote:Alright, I have a problem! I have a 20hp Kohler, I want to make it a go-devil. I don't want any cheap kits you can buy online. Then on the other hand I am not paying 2-3k on just a kit. So I'm going to build one with my papa and could I buy the grease fitting some where for the shaft? Any pictures or ideas on a build would be helpful to!
- Thankyou.
They are called zerk fittings, can be had just about anywhere.
That's not really what I'm talking about, look at SPS mud motor kits, the silver piece that connects to the drive shaft is what I need. Known as a coupler assembly?
Re: Custom Go-Devil.
Posted:
Sun Dec 21, 2014 10:52 pmby Goldfish
You can buy instructions online for roughly $30 that gives you a parts list and where to get the parts. That'd answer your questions better then we could I bet